E-flite Divo 3D - Manual (Page 26)

26 E-flite Divo 3D Profile Assembly Manual
Electronics Installation
Required Parts
Airframe assembly Hook and loop tape
Receiver Speed control
Motor battery Propeller
Required Tools and Adhesives
 1. Use hook and loop tape to mount the receiver to the
side of the horizontal fuselage. Route the antenna wire
from your receiver according to the instructions provided
with your radio system. Plug the servos into the receiver
at this time.
 2. Attach the speed control to the fuselage using hook
and loop tape. Secure the wires so they will not interfere
with the operation of the motor during flight.
 3. Apply hook and loop tape to the motor battery and
fuselage. Slide the motor battery into position.