E-flite Divo 3D - Manual (Page 28)

28 E-flite Divo 3D Profile Assembly Manual
Landing Gear Installation
Required Parts
Airframe assembly Wheel pant (2)
Wheel retainer (4) Landing gear strut (2)
1-inch (25mm) wheel (2) Nylon landing gear doubler (2)
Tail skid tubing
Required Tools and Adhesives
Foam-safe CA Foam-safe CA activator
Ruler
 1. Use foam-safe CA to glue the tail skid tubing onto
the tail skid. Leave about 1/8-inch (3mm) of the tubing
extending beyond the skid. The tube helps in quieting the
skid on hard surfaces.
 2. Slide the landing gear struts through the holes in the
bottom wing. Slide a nylon landing gear doubler onto
each of the landing gear struts. Insert each of the struts
into the opening in the fuselage. The struts will meet each
other in the middle of the fuselage.
 3. Check the alignment of the axles using a ruler. They
should be parallel or the tips should be slightly forward
to provide the best ground tracking.