E-flite Divo 3D - Manual (Page 24)

24 E-flite Divo 3D Profile Assembly Manual
 10. Attach the bend of the 12.4-inch (314mm) pushrod
to the rudder control horn.
 11. With rudder centered, secure the pushrod to the
connector at the rudder servo using a 2mm x 4mm
machine screw.
 12. Use foam-safe CA to glue the pushrod brace to the
fuselage in the hole closest to the rudder. Make sure to
position the brace so the pushrod will not bind on the
brace during flight. The rudder brace will go in the hole
closest to the rear.