Metrohm 861 Advanced Compact IC - Manual (Page 67)

3.3 Settings
861 Advanced Compact IC / Instructions for Use 8.861.1033
57
Suppressor Suppressor module «MSM II»
(inactive with version 2.861.0010)
Switch the suppressor module to the next posi-
tion. The time since the last switching of the
suppressor module is displayed in the field be-
side the button.
IC pump High-pressure pump
Start high-pressure pump.
Stop high-pressure pump.
Peristaltic pump Peristaltic pump
(inactive with version 2.861.0010)
Start peristaltic pump.
Stop peristaltic pump.
CO
2
Suppressor 853 CO
2
Suppressor
(only displayed with version 2.861.0040)
Start 853 CO
2
Suppressor.
Stop 853 CO
2
Suppressor.
System startup values The system startup values are sent and applied
to the 861 Advanced Compact IC each time the
system is connected, a determination is started,
or the values are sent manually with
unit> .
Flow, mL/min Startup value for flow rate of the high-pressure
pump.
Entry range: 0.20 ... 2.50 mL/min
Pressure max, MPa Startup value for maximum pressure limit for
high-pressure pump. This limit is controlled
even without connection to the PC.
Entry range:
0.0
...
35.0 MPa
If the Flow is higher than 1.5 mL/min, the defined
Pressure max must not exceed 25.0 MPa (250 bar).
Pressure min, MPa Startup value for minimum pressure limit for
high-pressure pump. This limit is controlled
even without connection to the PC.
Entry range: 0.0 ... 35.0 MPa
Full scale, µ S/cm Startup value for full scale range.
Selection: 50 , 250 , 1000, 5000 µ S/cm
Remote lines Startup value for remote line settings 1 … 8.
Selection: 0 , 1