Metrohm 784 KFP Titrino - Manual (Page 86)

3.2 Remote control commands
784 KFP Titrino
81
3.2.2.68. Info.ActualInfo.Assembly.Counter.V read only
Info.ActualInfo.Assembly.Counter.Clear $G
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G,
the volume counter is set to zero.
3.2.2.69. Info.ActualInfo.Assembly.Meas
read only
$Q sends the current measured value from the assembly.
3.2.2.70. Info.ActualInfo.Titrator.CyclNo
read only
Info.ActualInfo.Titrator.V read only
Info.ActualInfo.Titrator.Meas read only
Info.ActualInfo.Titrator.dVdt read only
Info.ActualInfo.Titrator.dMeasdt read only
Info.ActualInfo.Titrator.dMeasdV read only
Info.ActualInfo.Titrator.T read only
$Q sends the current values in the following formats:
KFT
CyclNo 127
V(mL) 1.2345
Meas:
Ipol (mV)
Upol (µA)
–345.6
–12.5
dVdt (µL/s) 2.5142
dMeasdt
Ipol (mV/s)
Upol (µA/s)
0.7957
0.7957
dMeasdV (mV/µL) 10.6326
NV: Not Valid.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.75). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.71. Info.ActualInfo.MeasPt.Index
read only
Info.ActualInfo.MeasPt.X read only
Info.ActualInfo.MeasPt.Y read only
Info.ActualInfo.MeasPt.Z1 read only
Info.ActualInfo.MeasPt.Z2 read only
Info.ActualInfo.EP.Index read only
Info.ActualInfo.EP.X read only
Info.ActualInfo.EP.Y read only
$Q sends the last entry into the measuring point list (.MeasPt) or the last en-
try into the list of EP's.