Metrohm 784 KFP Titrino - Manual (Page 65)

3.2 Remote control commands
784 KFP Titrino
60
&Info
Object Description Input range Reference
& Root
:
├
Info Current data
: ├
.Report Transmission of formatted reports $G 3.2.2.60.
│ ├
.Select Report type configuration, parameters,
│
smpl data, statistics, silo,
│
C-fmla, def, user method,
│
full, short, mplist, curve,
│
scalc full, scalc srt, calc,
│
all, ff ditto
│
├
.Checksums Checksums $G 3.2.2.61.
│ ├
.MPList Checksum of meas.point list read only ditto
│ ├
.ActualMethod Checksum of current method read only ditto
│
├
.DetermData Determination data $G 3.2.2.62.
│ ├
.Write Read/write for several nods ON, OFF
│ ├
.ExV Volume of Exchange/Dosing unit read only/read+write ditto
│ ├
.MPList Measuring point list
│ │ ├
.1 Measuring point 1
│ │ │ ├
.Attribute Attribute read only/read+write ditto
│ │ │ ├
.X X coordinate read only/read+write ditto
│ │ │ ├
.Y Y coordinate read only/read+write ditto
│ │ │ ├
.Z1 Z1 coordinate read only/read+write ditto
│ │ │ ├
.Z2 Z2 coordinate read only/read+write ditto
│ │ │
for each measuring point
│
├
.TitrResults Titration results
│ ├
.RS Calculated results
│ │ ├
.1 1 st result
│ │ │ ├
.Value Value read only 3.2.2.63.
│ │ ├
up to 9 results
│ ├
.EP Endpoint
│ │ ├
.1 1 st result
│ │ │ ├
.V Value read only ditto
│ │ │ ├
.Meas Measured value read only
│ │ │ ├
.Mark without meaning
│ │ ├
up to 9 EP's
│ ├
.Var Variables C4X
│ │ ├
.C40 Start measured value read only/read+write ditto
│ │ ├
.C41 Titration end volume read only/read+write
│ │ ├
.C42 Titration time read only/read+write
│ │ ├
.C43 Volume drift read only/read+write
│ │ ├
.C44 Titration temperature read only/read+write
│ │ ├
.C45 Start volume read only/read+write
│ │ ├
.DTime Time for drift corr.or dosing time read only/read+write