Metrohm 813 Compact Autosampler - Manual (Page 9)

1 Introduction
813 Compact Autosampler
3
1 Splash protection 6.2751.040
Must be installed always in operation!
14 Holding clamp
For locking the tubing cartridge into
place
2 Needle
PEEK needle 6.1835.020 or PEEK
tube 6.1835.010 or 6.1835.030
15 Snap-action lever
For releasing the tubing cartridge
3 Lift 16 Screw thread for splash
protection
4 Steel holder 4.766.4330
attached (part of 6.2833.000 Needle
holder)
17 PEEK capillary 6.1831.060 or
6.1822.410 (1 m or 1.2 m)
For conveying the sample to e.g. an
injection valve
5 PEEK compression fitting
4.766.4320
for connection of PEEK capillary 7
(part of 6.2833.000 Needle holder)
18 Tower
6 PEEK compression fitting
6.2744.010
19 Remote connection
7 PEEK capillary 6.1831.050
(40 cm)
connection needle – pump tubing
20 Plug cover 6.2752.010
8 Pump tubing 6.1826.040
For conveying the sample
21 Fuse holder
Changing the fuses, see section 2.2.2
9 Screw thread for splash
protection
22 Mains connection plug
Mains connection, see section 2.2.3
10 Mounting pin
For attaching the tubing
cartridge
23 Mains switch
For switching the instrument on/off:
I = ON 0 = OFF
11 Tubing cartridge 6.2755.000
For 6.1826.0X0 pump tubing
6.1826.0X0
24 Sample rack 6.2041.7500
12 Pump drive
Roller head with contact rollers
25 PP sample tube 6.2743.050
(can be sealed with 6.2743.060 PE
caps)
13 Contact pressure lever
For adjusting the contact pressure
26 Needle guide