DJI Z15-GH4 (HD - Manual (Page 25)

©2014 DJI. All Rights Reserved.
25
Zenmuse Z15-GH4 ( HD ) User Manual
Troubleshooting
NO. The Problem The Cause What to Do
1
The gimbal keeps drifting
after initialization.
(1) The TX trims are too high.
(2) The GCU and Flight
Control System have
been disconnected.
(3) The gimbal direction is
not pointing in the same
direction as the aircraft’s
nose.
(1) Adjust the TX trims.
(2) Connect the GCU and Flight
Control System.
(3) Ensure the gimbal direction is
pointing in the same direction
as the aircraft’s nose.
2
The gimbal is in an
incorrect position after
initializing.
Abnormal calibration after
manufacturing. Please contact your local dealer
or DJI customer service.
3
Cannot distinguish the
gimbal’s direction when in
use.
BVR (Beyond Visibility
Range) flight.
Switch to FPV Mode first, then
to another Working Mode as
needed.
4
The gimbal LED is blinking
red.
(1) There is a disconnected
cable between the gimbal
and camera.
(2) The camera is off.
(3) Camera setup failure.
(1) Make sure all cables are
securely connected.
(2) Power on the camera.
(3) Set the HDMI resolution to
1080i.
5
The gimbal’s green or
yellow LED is continuously
on, but no video is
displayed.
(1) The HDMI-HD/AV
transmission module is
disconnected from the
camera.
(2) The camera is powered off.
(3) In HD mode, the DJI
Lightbridge App video
source has been set to
“HDMI/AV”.
(1) Check HDMI-HD/AV
transmission module
connection.
(2) Power on the camera.
(3) Change the DJI Lightbridge
App video source to "HD
Gimbal".
Appendix