Appendix, Attention, Pilot solution – DJI Z15-GH4 (HD User Manual

Page 22: Gh4-hd

Appendix

Attention

For safety reasons, please pay careful attention to all of the following items:
1. To avoid motor damage, ensure nothing blocks the servo drive module’s total range of movement.
2. Before powering on, spin the gimbal through its complete rotation by hand on each axis to ensure nothing

is blocking the mechanical movement of the gimbal.

3. Be sure to mount the side of servo drive module 1 with the ports facing towards the aircraft tail.
4. The gimbal’s center of gravity has been preset. The gimbal balance is directly related to its performance.

Please do not adjust the gimbal’s center of gravity by yourself.

5. The gimbal is a sophisticated device. Do not remove any screws from the gimbal. Doing so may result in

poor performance or even damage.

6. Do not unplug any cables attached to the gimbal ports or change the mechanical structure.
7. Make sure all wiring is correct, otherwise the gimbal may not operate correctly or efficiently.
8. Make sure to connect the wireless video transmission module to the GCU prior to powering on the system.
9. We recommend use of the included AV video power cable, if needed.
10. Be sure to solder the AV video power cable to the wireless video transmission module correctly. Ensure

the cables are insulated and protected to prevent any type of short circuit.

11. Pay close attention to the voltage of S800 EVO/S1000 and be sure it is within the defined limits (6S) when

using one battery for both the S800 EVO/S1000 and as a power supply for the gimbal.

12. Never touch the contact points of a power cable to the gimbal; this may lead to a short circuit of the

gimbal, resulting in complete failure.

13. Before powering on, adjust the roll axis of the gimbal to be level.

1-Pilot Solution

14V

52V

Flight Controller

（DJI WooKong-M）

GCU

ROLL

TILT

PAN

MODE

SHUT

AUX1

AUX2

AUX3

Gimbal Control Unit

（GCU）

3-Position Switch

2-Position Switch

3-Position Switch

14 Channels Receiver(Futaba)

Gimbal Control

Flight Control

Transmitter

GH4-HD

Appendix