DJI H3-3D Anti-interference Reinforcement Board - Manual

DJI H3-3D Anti-interference Reinforcement Board
Connection Chart
The Anti-interference Reinforcement Board is an accessory of the DJI H3-3D (For Phantom 2 Only
version ), you may follow the connection chart above to connect the Phantom 2 and H3-3D with
the board. Please pay attention to the Input and Output ports of the board. There are two ways
to mount the board, you can use a 3M double-side tape to fix it at the bottom of the Phantom 2,
OR you can mount the board directly inside the Phantom 2 as shown in the picture below.
8PIN Port (Phantom 2) 8PIN Port (H3-3D)
Anti-interference Reinforcement Board of H3-3D
Phantom 2
H3-3D
8PIN Cable of Phantom 2
8PIN Port of H3-3D