DJI WooKong-M - Manual (Page 7)

©2013-2014 DJI Innovations. All Rights Reserved. 7 |
Step
2
Software and Driver Installation on a PC
1. Please download the drive installer and the assistant software from DJI website.
2. Connect the autopilot system and the PC via a USB cable, and power on the autopilot system.
3. Run the driver installer, and follow the instructions strictly to finish installation.
4. Run the assistant software installer, and follow the instructions strictly to finish installation.
Step
3
Configuration by Assistant Software on a PC
1. Power on the PC. Make sure your computer is connected to the Internet for the first time you use.
2. Switch on the transmitter first, and then power on the autopilot system. Connect the autopilot system to
the PC with a Micro-USB cable. DO NOT break the connection until setup is finished.
3. Run the Assistant Software.
4. Observe the indicators on the left bottom of the software. ( connection indicator and
communication indicator) If the connection indicator is communication indicator is blinking, that the
software is ready, please go to next step.
5. Select the “Info” option. Check the software and the firmware version.
6. Select the “Basic” option. Please follow step-by-step for your first-time-configuration. Basic configuration
is necessary, including Mixer Type, Mounting, RC, and Gain settings.
7. You can click the “Advanced” option for more parameter settings. Advanced setting is optional. There are
settings of Motor, FailSafe, Intelligent Orientation Control (IOC), Gimbal, Low-Voltage Alert, and Flight
Limits. Read the instruction in the assistant software to obtain more details.
8. Select the “Viewer” option and check all parameters.
 You may be required to fill register information for your first-time-usage.
 If the communication indicator is , please double check the connections.
 Basic configuration is necessary before you go to the “Basic Flying Test”.
 If the software and the firmware upgrade are available, please upgrade the assistant software
and the firmware by referring to the Appendix.
 This step is required to use together with the assistant software to obtain more details.
Recommended Settings for the users with F450/F550/S800/Z15.
Configuration Information Basic Attitude
Motor ESC Propeller Battery Weight Pitch Roll Yaw Vertical Pitch Roll
F450 DJI-2212 DJI-30A DJI-8 Inch 3S-2200 890 g 150 150 100 105 150 150
F550 DJI-2212 DJI-30A DJI-8 Inch 4S-3300 1530 g 170 170 150 140 170 170
S800 DJI-4114 DJI-40A DJI-15Inch 6S-15000 4770 g 200 200 195 175 190 190
S800+Z15 DJI-4114 DJI-40A DJI-15Inch 6S-10000 6100 g 240 240 200 200 220 220
S800 EVO DJI-4114 PRO DJI-40A DJI-15 Inch 6S-15000 6700 g 130 130 150 150 180 180
*S800 with damping kit can use the same values as S800 EVO.