DJI WooKong-M - Manual (Page 20)

©2013-2014 DJI Innovations. All Rights Reserved. 20 |
WM Assistant for Mobile Device
Step
1
Assemble the LED Bluetooth Module
ANT
LED Indicator
LED Bluetooth Module
Status Indicator
The LED Bluetooth Module is necessary if you are using the WM Assistant. This module is
only for the iOS Device, not for android equipment. Its Operating Temperature range is
from -5°C to +60°C. Please refer to the Assembly & Configuration -> Step1 Assembly to
attach the module.
This module has a USB interface for configuration and firmware upgrades when
connecting to PC. The “LED Indicator” tells the status of autopilot system, and the “LED
Bluetooth Module Status Indicator” tells whether the LED Bluetooth Module is working
or not. The built-in Bluetooth is for wireless communication between the autopilot system
and mobile equipment, with a maximum communication distance of 50m.
Step
2
WM Assistant Installation
Please search the WM Assistant from the App Store by your iOS device, download and install it.
Step
3
Parameter Configuration Procedures
1. Prepare an iOS Device that supports Bluetooth 4.0, and turn on the Bluetooth.
2. Switch on the transmitter first, power on the autopilot system. The LED Indicator blinks ( ……) when
self-check. After that, check the LED Bluetooth Module Status Indicator, if it is solid red on, then the LED
Bluetooth Module is working normally.
3. Run the WM Assistant. The LED Indicator blinks Purple and Yellow alternately ( ) when the WM
Assistant is connected to the autopilot system. Make sure your iOS device is connected to the Internet
for the first time you use, to register account. And also you can login with the PC assistant account.
4. Run the WM Assistant. Set up the name and password for autopilot system according to the App start.
5. Observe the indicators on the left bottom of the software. ( connection indicator and
communication indicator) On the WM Assistant, if the communication indicator is , please double check
the connections and driver installation; otherwise if the indicator is blinking , go to next step.
6. Select the “Basic” option. Please follow step-by-step for your first-time-configuration. Basic configuration
is necessary. Click the icon to get the configuration details.
7. You can click the “Advanced” option for more parameter settings. Advanced setting is optional. There are
Motor, Enhanced Fail-Safe, Intelligent Orientation Control (IOC), Gimbal, Low-voltage Alarm, Flight
Limits, etc.
8. Select Viewer and check all parameters.
9. Select “More” to obtain more details. Including: (Parameter)Import-Export, Restore Factory Settings,
Account, Main Controller List, Information( including Hardware ID, IMU, Loader, Firmware, SN and
Functions Activation Status), Rate WM Assistant, Feedback, About(Help Document, Disclaimer)