DJI WooKong-M - Manual (Page 19)

©2013-2014 DJI Innovations. All Rights Reserved. 19 |
 Switching from Standby to Start will enable go-home during flight and you will no longer have
flight control of the Multi rotor. If the multi-rotor is already in a failsafe condition, then the
go-home switch will not work.
 If you switch to Manual Mode or Atti. Mode, (and the multi rotor is not in a fail-safe condition),
then the go-home is cancelled and you regain control of the multi copter. Once GPS. Mode is
re-selected you can once again use the go-home function.
 Use end-point fine tuning on your transmitter to adjust the X3 channel, to give the correct
switch indication in the assistant software.
 The following example shows how to enable Go-home by the Tx Switch. Use position-1 to Start
and Position-2 to Standby for example.
Position -1 Position -2 Position -1, if the initial switch position is at Start (Position -1).
Position -2 Position -1, if the initial switch position is at Standby (Position -2).
 The home point of the ground station one key go-home is the same as the point set by user in
the ground station software.
 If the home point is not set by the ground station, the home point of the ground station one
key go-home function is the point recorded by the MC.
 If the Go-Home Switch cannot be selected in the assistant software, that may be due to the X3
channel been set for remote gain tuning, you should change this if required.