Calculated Industries 4095-A User Guide - Manual (Page 42)

40 — P
iPe
T
rades
P
ro
™
Errors — When an incorrect entry is made, or the answer
is beyond the range of the calculator, it will display the word
“ ERROR.” To clear an error condition you must hit the 
button once. At this point you must determine what caused the
error and re-key the problem.
ERROR CODES
DISPLAY ERROR TYPE
OFLO Overflow (too large)
MATH Error Divide by 0
DIM Error Dimension error
ENT Error Invalid entry error
Auto-Range — If an “overflow” is created because of an
input and calculation with small units that are out of the
standard seven-digit range of the display, the answer will be
automatically expressed in the next larger units (instead of
showing “ ERROR”) — e.g., 20,000,000 mm is shown as 20,000
m. Also applies to inches and feet.
AUTO SHUT-OFF
Your calculator is designed to shut itself off after about 8-12
minutes of non-use.
BATTERIES
The Pipe Trades Pro uses two LR-44 batteries.
Replacing Batteries
Should your calculator display become very dim or erratic,
replace the batteries.
Note: Please use caution when disposing of your old battery,
as it contains hazardous chemicals.
Replacement batteries are available at most discount or
electronics stores. You may also call Calculated Industries at
1-775-885-4900.
UG4095E-A.indd 40 5/5/2009 9:09:35 AM