Calculated Industries 4095-A User Guide - Manual (Page 37)

U
ser
’
s
G
Uide
— 35
following settings (in addition to those listed on the previous page):
*Depressing the Reset button located above the  will also
perform a Full Reset. Asterisks below indicate default values.
Preference Options
1) Fractional Resolution – * 1/16 (displays fractional values
to the nearest 16th of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
2) Area Display Format – * Standard (if units entered are
the same—e.g., Feet x Feet—the
answer will remain in this format
(Square Feet), but if units entered
are different — e.g., Inches
x Feet—area answer will be
displayed in Square Feet)
– Square Feet (area answers
always displayed in Square Feet,
regardless of unit entry — e.g.,
Inches x Inches = Square Feet)
– Square Inches (area answers
always displayed in Square Inches
— e.g., Feet x Feet = Square Inches)
– Square Meters (area answers
always displayed in Square Meters
— e.g., Feet x Feet = Square Meters)
3) Volume Display Format – * Standard (if units entered are
the same — e.g., Feet x Feet x
Feet — the answer will remain
in this format (cu. ft), but if units
entered are different — e.g., Feet
x Feet x Inches — vol. answer will
always be displayed in Cubic Feet)
– Cubic Feet (vol. answers always
UG4095E-A.indd 35 5/5/2009 9:09:35 AM