Calculated Industries 4095-A User Guide - Manual (Page 39)

U
ser
’
s
G
Uide
— 37
Access each category by pressing the  key until you reach
the desired setting. Within each category, press the  or

keys to toggle between individual selections. Press  to
exit and set your Preference.
Note: Press  to advance and press  to back up. Pressing
the  key continuously in this mode will cycle through all of
the Preference Settings.
You may change these settings at any time by repeating the
above, and setting in a new preference.
To reset preferences back to factory default settings, turn your
calculator off, hold down the  key and turn the calculator
back on.
For example, if you wish to display all your dimensional area
answers in square meters, press 

 (Area Std),
then the  key until “AREA 0. SQ M” is displayed. Simply exit
this mode by pressing  and all your future area answers
will be displayed in square meters.
KEYSTROKES DISPLAY
 
(Fractional Resolution) FRAC 0 1/16 INCH

FRAC 0 1/32 INCH

FRAC 0 1/64 INCH

FRAC 0 1/2 INCH

FRAC 0 1/4 INCH

FRAC 0 1/8 INCH
 (repeats options) FRAC 0 1/16 INCH
Second press of  :
(Area displays) AREA Std.

AREA 0. SQ FEET

AREA 0. SQ INCH

AREA 0. SQ M

(repeats options) Std.
Third press of  :
UG4095E-A.indd 37 5/5/2009 9:09:35 AM