Calculated Industries 4095-A User Guide - Manual (Page 19)

U
ser
’
s
G
Uide
— 17
Using Memory Storage Keys (M1 - M9)
In addition to the standard cumulative Memory (as previously
described), your calculator has nine independent Storage
Registers – M1 through M9 – that can be used to permanently
store single, noncumulative values. The following example
shows the use of M1 ( ). To use M2 - M9, replace the
presses of the  key with presses of the corresponding
number key ( - ).
You can replace a value in one of these Memory registers by
storing a new value in place of the stored value.
FUNCTION KEYSTROKES
Store single value in M1
 
Clear M1

 
Recall M1
 
Example: Store 175 into M1, recall the value, and then clear
the value.
KEYSTROKES DISPLAY

    M-1 175.
  0.
  M-1 175.

  M-1 0.
PaPERlESS TaPE
The Paperless Tape allows you to display and review the last
30 entries of a calculation.   accesses the tape mode
and  or  scrolls forward or backward through the entries.
Note: The Paperless Tape is cleared each time  is
pressed twice, the unit is shut off, or an All Clear ( ) is
performed.
UG4095E-A.indd 17 5/5/2009 9:09:30 AM