Calculated Industries 4095-A User Guide - Manual (Page 13)

U
ser
’
s
G
Uide
— 11
EnTERinG dimEnSionS
Linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing 
(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.
Examples of how linear dimensions are entered (press 
after each entry):
DIMENSIONS KEYSTROKES
5 feet


5 feet, 1 ½ inches

     
17.5 meters

   
1250 millimeters

   

Square and Cubic Dimensions
Examples of how square and cubic dimensions are entered
(press  after each entry):
DIMENSIONS KEYSTROKES
14 square inches

  
11 square feet

  
3.3 square meters

   
3 cubic feet

  
EnTERinG convERSionS
Linear Conversions
Convert 10 feet 6 inches to other dimensions, including metric:
UG4095E-A.indd 11 5/5/2009 9:09:29 AM