Brother MFC-730 - Manual (Page 179)

167
I M P O R T A N T I N F O R M A T I O N
Any other usage will invalidate the approval of the apparatus, if as a
result it then ceases to comply with the standards against which approval
was granted.
The machine is approved for connection to a single exclusive direct
exchange line provided by BT, Kingston-upon-Hull Telecommunications
and CATV, and to approved Private Automatic Branch Exchanges
(PABXs).
The connection to the BT network must not be hard-wired.
This equipment is NOT approved for connection to the following:
I + I Carrier Systems;
Leased Lines;
Shared Service (“Party”) Lines;
As an extension to a Payphone;
Calls to the emergency services (999) DO NOT remain enabled on
the handset in the absence of mains power.
Stored telephone numbers are retained in the absence of mains power.
The loudspeaking facility (call progress monitor) will not function unless
the unit is plugged into the mains and switched on at the power socket of
the mains switch if applicable.
This owner’s manual has been provided with your machine to help you
make use of the functions provided.
This machine must not be connected in conjunction with parallel
extension telephones, unless those telephones are connected downstream
of this machine. This means that the cable to which any extension device
is connected, should be terminated on a BT modular jack plug type 431A
which in turn is inserted into the modular socket of the T-shaped line
cord connector of this machine. If these instructions are not followed, the
following conditions may occur:
1. The fax machine inadvertently auto-answers in response to outward
pulse dialling of an extension telephone.
2. Fax transmissions can be impaired or will fail entirely.
3. Remote activation from extension telephones may not work correctly.
If in doubt about any aspect of telephone extension cabling, contact BT,
Kingston upon Hull Telecommunications, your PBX maintainer, your
CATV company or a reputable telephone cabling company.
Radio Interference (220-240 V Model Only)
This machine complies with EN55022 (CISPR Publication 22)/Class B.
A shielded interface cable should be used to ensure compatibility with
the above specification.