Brandmotion 2000-4103 - Manual (Page 2)

4100 - 4103 Instructions 5-17-13.docx Page 2 of 3
Step 5. Use an X-Acto Knife or Roto Tool to cut
clearance hole in the substrate.
Step 6. Determine how many (if any) of the
supplied 2mm thick Foam Gaskets are required
for snug fit of Module. For example, a
compressible 8mm substrate will not need a
gasket, but a 4mm substrate will require two
2mm Gaskets. Gaskets may be used on the
front or back side of the substrate. If substrate
has a slight crown to the surface, it is
recommended to use Gaskets on the front side.
Module Wiring
Step 7. Use a multimeter to test for vehicle
Ignition Power (+), Courtesy or Constant 12v
Power (+),and Ground. Wires providing these
functions may be present in the vehicle
headliner or overhead console. Other typical
locations are behind the driver or passenger
side kick panel or under the dash. Set parking
brake, start vehicle, and test for the appropriate
signals.
Step 8. Use three supplied Posi-Taps to connect
supplied Wiring Harness wires to the following
required connections:
(NOTE: For Posi-Tap use instructions, link to
www.posi-­‐lock.com/posiplug.html)
Red* – This wire powers HomeLink
functions. You must choose whether to
connect to 12v+ Constant power (unit will
function anytime vehicle power is on) OR
12v+ Ignition Controlled power (unit will
function only when key is ON).
White* – This wire powers Module button
backlighting. Connect to Illumination/
Backlighting power (Module button
backlighting will illuminate when vehicle
lights are on) or Ignition Controlled power
or (Module button backlighting will
illuminate only when key is ON).
Black – Connect to Chassis Ground.
*If desired, both the Red and White wires
can be connected to the same wire
supplying Ignition Controlled power.
Harness Pinout
PIN
WIRE
COLOR
FUNCTION CONNECTION
1 Red
HomeLink
functions
Constant power
12v (+)
OR
Ignition Controlled
power 12v (+)
2 White
Button
backlighting
Illumination/
Backlighting power
OR
Ignition Controlled
power 12v (+)