Brandmotion 9002-1005 - Manual (Page 5)

INSTALLATION
INSTRUCTIONS
1005 Instructions 11-11-13.doc 5 of 5
Connect & Secure Chassis Harness
34. Plug the RCA connector end of the supplied Chassis
Harness into Video In your aftermarket display.
35. Route supplied Chassis Harness along existing
chassis harness toward rear of vehicle, staying clear
of body mounts. (Figure 16)
Figure 16
36. Connect supplied Chassis Harness to Tailgate Handle
Camera harness.
37. Secure supplied Chassis Harness along the existing
Chassis Harness using Wire Ties (recommended)
every 200mm (approximately 8”). Note: Depending
on vehicle wheelbase there may be excess length in
the Chassis Harness. Loop, and secure with Wire
Ties (recommended) or Electrical Tape, any excess
harness length along the Body Frame away from
Mechanical areas.
38. Reconnect negative battery terminal. Tighten
negative cable nut to 5 N·m (44 lb in).
39. Test system functionality: start vehicle, apply brake,
and shift into Reverse. The camera image should
appear in your aftermarket display.
40. Re-install all previously removed trim.