Brandmotion 9002-1005 - Manual (Page 2)

INSTALLATION
INSTRUCTIONS
1005 Instructions 11-11-13.doc 2 of 5
7. Disengage (2) plastic Latch Rod Retainer Clips using
your fingers. (Figure 2)
Figure 2
8. Remove (2) Bolts securing the Tailgate Handle using
a 10mm Socket. (Figure 3)
Figure 3
9. Use your fingers to press down on the (2) retainer
clips securing the Tailgate Handle to the Tailgate
outer panel. Lift the Tailgate latch handle in order to
aid in removing the Tailgate Handle.
10. Remove lock cylinder from original Tailgate Handle.
Remove Tailgate Lock Cylinder Retaining Clip and
then Tailgate Lock Cylinder and reinstall into
supplied Tailgate Handle Camera. (Figure 4)
Figure 4
11. Route gray Tailgate Handle Camera connector down
through Tailgate Handle opening then out through
the hole at bottom of Tailgate.
12. Pull gray Tailgate Handle Camera connector through
the pass-through hole in the rear of the pickup box.
13. Engage (2) clips of Tailgate Handle Camera
Assembly into Tailgate until it clicks into place and
reinstall (2) Bolts using a 10mm Socket.
14. Reattach (2) plastic Latch Rod Retainer Clips using
your fingers.
15. Reattach (8) screws securing Tailgate Access Panel
using a T15 Torx bit.
16. (If equipped), reinstall plastic Tailgate Protector.
17. Close Tailgate.
Drill Chassis Harness Pass Through
18. Using a Plastic Trim Removal Tool, remove Left
Instrument Panel Outer Trim Cover. (Figure 5)
Figure 5
19. Remove driver side door sill cover/kick panel cover.
(Figure 6)
Figure 6