Brandmotion 9002-7630 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
7630 Instructions 1-16-13.doc Page 3 of 4
Step 4: Route Camera and/ or Chassis
Harness along existing wiring and secure
using wire ties or electrical tape. IMPORTANT:
Ensure harnesses move freely with the trunk or
liftgate.
Step 5: Route Chassis Harness forward. It
may be necessary to remove sill plates, pillar
covers, seat bottoms, side panels, etc. Use a plastic
trim removal tool to avoid damage to trim pieces.
In some cases, seatbelt bolts at the bottom of the
pillars must be removed. (CAUTION: Any bolts
removed for safety devices must be retightened to
manufacturer’s specified torque specifications.)
Step 6: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this
junction may occur at the top of the liftgate or
inner trunk edge.
Step 7: Route Chassis Harness. It may be
necessary to remove sill plates, pillar covers, seat
bottoms, side panels, etc. In some cases even the
seatbelt bolts at the bottom of the pillars must be
removed (CAUTION: Any bolts removed for safety
devices must be retightened to manufacturer’s
specified torque specifications). Use a plastic trim
removal tool to avoid damage to trim pieces.
Step 8: Use a plastic trim removal tool,
10mm socket, and Phillips screwdriver to
remove garnish and fasteners securing the
radio display.
Step 9: Remove the radio and disconnect the
smaller white 16-pin connector.
Step 10: Plug the white 16-pin radio
connector into the female end of supplied
Jumper Harness.
Step 11: Plug the male 16-pin connector of
supplied Jumper Harness into the radio.
Step 12: Route supplied Chassis Harness
under carpet to the center console area.
CAUTION: Keep harness away from accelerator,
brake pedal, and parking brake assembly.
Step 13: Connect Chassis Harness to supplied
Jumper Harness RCA and power plugs.
Step 14: Use wire ties or electrical tape to
secure Chassis Harness and Jumper Harness
RCA and power connections.
Step 15: Coil any excess Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with wire ties or electrical
tape.
Step 16: Reinstall radio display and inspect
that all connections are proper and secure.