Brandmotion 9002-7630 - Manual (Page 2)

INSTALLATION
INSTRUCTIONS
7630 Instructions 1-16-13.doc Page 2 of 4
Step 1: Select and Install Camera Bracket
Determine which of the two supplied camera
mounting methods you prefer:
License Plate Bracket
Alternate Camera Mount Bracket
Place camera in desired position to confirm
fitment (IMPORTANT: Some states prohibit items
blocking the license plate; check local authorities to
confirm legal status for your application).
If using the License Plate Bracket, remove
license plate. Reattach license plate with supplied
License Plate Bolts securing bracket behind.
(NOTE: License plate frames may require trimming
to be used with the License Plate bracket.)
If using the Alternate Camera Mount
Bracket, remove the camera from License Plate
Bracket using the supplied Allen wrench. Attach
camera to the Alternate Camera Mount bracket and
apply supplied Self-adhesive Foam Pad to the back
of the bracket.
Use the Template included on Page 1 to
position the Alternate Camera Mount Bracket on
the vehicle.
Clean vehicle surface to which mount is to be
attached and affix by exposing the other side of the
Self-adhesive Foam Pad. (RECOMMENDED:
Permanent attachment using screws.)
Step 2: Measure, mark, and drill a ¼” hole
for the Camera Harness. NOTE: If your vehicle
has a liftgate panel/ trunk trim cover, it must be
removed.
Step 3: Insert connector end of the Camera
Harness through the hole you drilled.
(RECOMMENDED: Protect Camera Harness from
sharp metal edges by applying a small amount of
silicone caulk or a rubber grommet (shown) to the
area that comes into contact with the metal).