Brandmotion 9002-8538 - Manual (Page 9)

INSTALLATION
INSTRUCTIONS
8538 Instructions 5-27-14.docx Page 9 of 9
Step 21: Plug the vehicles 20-pin radio
connector into the female 20-pin connector of
supplied Display Harness.
Step 22: Plug the male 20-pin connector of
supplied Display Harness into the radio.
Step 23: Connect Power Harness male RCA
connector to Display Harness female RCA
connector.
Step 24: Test the system. Inspect that all
connections are proper and secure. Clear all loose
items removed from the area around the vehicle
and turn ignition key ON to test system. Once
Reverse gear is engaged the camera image
should appear.
Step 25: Secure Chassis Harness. If necessary,
coil excess harness and secure. Attach harness to
existing vehicle wiring where possible.
(RECOMMENDED: Wire Ties or Electrical Tape.)
Step 26: Adjust camera aim. With the aid of an
assistant, move camera to desired view. Use a
Phillips screwdriver to fully tighten the bolts that
hold the camera in place.
Step 27: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care
not to bind the harness wiring when reinstalling.