Brandmotion 1009-6504 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
6504 Instructions 2-4-14.Doc Page 3 of 6
12. Route the gray Camera Harness connector and
wiring through tailgate and install supplied handle
using an 8mm Socket with the existing hardware.
13. Reinstall handle bolts.
14. Route the supplied Camera Harness through the
pass-through hole in the inner brace of the tailgate.
15. Seat Camera Harness grommet in the pass through
hole you drilled in the tailgate using your fingers
16. Taking care not to damage the Camera Harness,
reinstall tailgate by lifting it into place, rotating it
down about ten degrees, and sliding it to the left.
17. Reinstall both tailgate straps by placing the large
opening of the tailgate strap hangers over the
tailgate strap mounts and pulling down.
18. Feed the gray end of the Camera Harness through
the rectangular opening at the rear of the truck bed.
Install Chassis Harness
19. Remove front driver’s side kick panel/sill plate by
lifting it at the rear and working your way forward
with your hands.
20. Remove rear driver’s-side sill plate by lifting it at
front and working your way back with your hands.
21. Lift driver’s side rear seat to expose the under seat
storage compartment. Pull three pushpins out of the
driver’s side rear seat storage compartment using a
Pushpin Removal Tool.