Bowers Group Trimos Mestra Height Gauges - Manual (Page 19)

750 50 0001 03
19/28
7 Programmable function keys
The operating handle of the instrument includes one key to
activate the air cushion displacement of the instrument (Air)
and 2 programmable function keys, one yellow key (1) and
one blue key (2). The pre-programmed functions of this 2
keys are as follows :
1. Yellow key:
Preset
2. Blue key: Functions
Other functions can be allocated to these keys, see § 8.
8 Configuration (Set-up)
Certain parameters of the instrument can be configured
according to the user requirements.
To open this Set-up menu, press the Functions key longer
than 2 seconds.
> 2 sec.
The cursor keys allow the selection of the different elements
in the menu. The yellow arrow indicates the cursor position.
The Enter key allows to activate / cancel the configuration
fields.
For selection of the next page, press the Functions key,
To quit the Set-up menu, press the Enter key longer than 2
seconds.
> 2 sec.
Page 1
1. Locking of the measuring unit (mm or inch):
By activating one or the other field, the mm/inch key will
be locked in for one or the other measuring unit. The
instrument display will than only work in the selected unit.
2. Height of the setting gauge :
If another setting gauge than the supplied one will be
used, it is possible to enter its height.
The checking and storage of the constant must always be
done between 2 inverted surface without moving the
instrument or the reference gauge.
3. Angle unit format:
x.x°: Decimal degrees
x° x' x": Degrees, minutes, seconds
rad: Radians
4. Height of the gauge block for measuring angles:
By activating the required field, the last 2 steps of the
angle measurement will be cancelled. The height of the
gauge block will be taken over.
1
2
1
2
3
4