Brother ULT 2003D - Manual (Page 30)

Setting Up 1-19
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?!
9 —
CONTENTS
Index
Checking the Application
The application can be started up from the floppy disk.
If the machine is turned on with the floppy disk inserted, the machine imports the application from
the floppy disk, then starts it up.
1. Press to open the screen at left.
2. Press to go to the next screen.
3. Press beside until it changes to , and
then press .
4. Turn off the machine.
5. Insert the floppy disk containing the application into the floppy
disk drive slot on the right side of the machine, and then turn on
the machine.
CAUTION
• Do not insert anything other than floppy disks into the floppy
disk drive slot, otherwise the floppy disk drive may be dam-
aged.
• Do not insert a floppy disk containing pattern data other than
those saved using our application, data design equipment or a
sewing machine, otherwise the sewing machine may malfunc-
tion. (Only .pes, .phc and .dst pattern files can be used.)
6. After the sewing machine reads the floppy disk, it starts up.
CAUTION
Do not turn off the machine or eject the floppy disk while the
machine is reading the disk, otherwise the disk may be damaged.
7. With your finger, lightly press the opening screen. A screen that
allows you to select the sewing machine or the application ap-
pears.
* If a floppy disk that does not contain the application is in-
serted, the Utility Stitch screen appears.
* If Application Check was set to “ON”, it may take some time
until the machine starts up. If you do not wish to use the applica-
tion and Application Check is set to “OFF”, the length of time for
the machine to start up does not change.