Brother ULT 2003D - Manual (Page 152)

Sewing Character/Decorative Stitches 4-9
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?!
9 —
CONTENTS
Index
6
5
6
5
6
5
Basic Sewing of Character/Decorative Stitches
1. Select a stitch pattern.
2. Attach monogramming foot “N”.
3. Place the fabric under the presser foot, pull the upper
thread out to the side and then lower the presser foot.
4. Press the “Start/Stop” button to begin sewing.
CAUTION
When sewing 7 mm satin stitch patterns and the
stitches are bunched, lengthen the stitch length.
If you continue sewing when the stitches are
bunched, the needle may bend or break. (See “Set-
ting the Stitch Length”.)
* If the fabric is pulled or pushed during sewing, the pat-
tern may not turn out correctly. Also, depending on
the pattern, there may be movement to the left and
right as well as front and back. Therefore, guide the
fabric with your hand to keep the fabric feeding straight
and even during sewing.
5. Press the “Start/Stop” button to stop sewing, then press
the “Reverse/Reinforcement Stitch” button to sew re-
inforcement stitches.
When Sewing Character Stitches
When sewing is finished, the machine will automatically
sew reinforcement stitches, then stop.
Note
When sewing character stitches, the machine automati-
cally sews reinforcement stitches at the beginning and end
of each character.