Attaching 4 hole buttons -62, Caution – Brother ULT 2003D User Manual
Page 135
3-62
Sewing Utility Stitches
1
6
4. Turn the balance wheel to check that the needle goes
into each hole correctly. Then, gently hold the end of
the upper thread and start sewing. The machine stops
automatically when sewing is finished.
CAUTION
Make sure the needle does not strike the button
during sewing. The needle may break, leading to
injury.
Note
• To attach the button more securely, repeat the process.
• If the needle does not reach the holes on the left side,
adjust the stitch width.
5. From the wrong side of the fabric, pull the end of the
bobbin thread to pull the upper thread through to the
wrong side of the fabric. Tie the two thread ends to-
gether and cut the threads.
■ Attaching 4 Hole Buttons
Sew the two holes closest to you. Then raise the presser
foot lever and move the fabric so that the needle goes into
the next two holes, and sew them in the same way.
6. When sewing is completed, be sure to return the feed
dog position switch to its original position.
1
Feed dog position switch