Autocue SSP10 Quick Start - Manual (Page 29)

Use your prompter in different situations
SSP-QStartUserManual.docx 2011-06-15
29 © 2003-2011 Autocue Group Ltd.
4. Change the monitor mounting plate
5. Screw your tripod head mounting plate into the threaded hole at the bottom of the
vertical frame
6. Mount the vertical frame onto your chosen tripod and fasten securely
7. Align the holes in the edge of the mounting plate with the slide nuts in the edge of
the vertical frame
8. Loosely screw in four thumb screws
9. Adjust the position of the monitor by sliding it up and down the vertical frame
10. Fasten the monitor in position by tightening the thumb screws fully