Autocue SSP10 Quick Start - Manual (Page 24)

Use your prompter in different situations
SSP-QStartUserManual.docx 2011-06-15
24 © 2003-2011 Autocue Group Ltd.
Use your prompter in different situations
You may not always need to use your prompter with a camera. The Starter Series hardware is designed to
give you five alternative mounting arrangements depending on how you wish to use your system.
Note: When altering the position of the different components of your Starter Series
Prompter, always handle with care to avoid damaging them, especially the mirrored
glass.
Use the following procedures where required when rearranging the components of your prompter into
the different configurations.
1. Remove the hood and mirrored glass
1. Locate the four thumb screws that attach the hood to the vertical frame
2. Remove the thumb screws
3. Carefully take the hood off the frame and store on a smooth, flat surface
2. Remove the monitor
1. Locate the four thumb screws that attach the monitor to the base of the prompter
2. Remove the thumb screws
3. Carefully take the monitor off and place on a smooth, flat surface
3. Remove the vertical frame
1. Locate the four thumb screws that attach the vertical frame to the base of the
prompter