Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 29)

Configuring the ControlNet Module 4-9
14 DPI I/O Active
I/O that the module is actively transmitting. The
value of this parameter will usually be equal to the
value of parameter 13 - DPI I/O Config. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read Only
Bit Definitions
0 = Cmd/Ref
1 = Datalink A
2 = Datalink B
3 = Datalink C
4 = Datalink D
5 = Not Used
6 = Not Used
7 = Not Used
25 M-S Input
Configures the I/O Data to be transferred from the
network to the drive. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read/Write
Reset Required: Yes
Bit Definitions
0 = Cmd/Ref
1 = Datalink A
2 = Datalink B
3 = Datalink C
4 = Datalink D
5 = Not Used
6 = Not Used
7 = Not Used
26 M-S Output
Configures the I/O Data to be transferred from the
drive to the network. Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read/Write
Reset Required: Yes
Bit Definitions
0 = Cmd/Ref
1 = Datalink A
2 = Datalink B
3 = Datalink C
4 = Datalink D
5 = Not Used
6 = Not Used
7 = Not Used
27 Ref Adjust
Percent scale factor for the Reference from the
Network. Default: 100.00
Minimum: 0.00
Maximum: 200.00
Type: Read/Write
Reset Required: No
Table 4.4 – Module Configuration Status Parameters
No. Name and Description Details
Bit
Default 1 0 0 0 0 x x x
0 1 2 3 4 5 7 6
Bit
Default 1 0 0 0 0 x x x
0 1 2 3 4 5 7 6
Bit
Default 1 0 0 0 0 x x x
0 1 2 3 4 5 7 6