Rockwell Automation RECOMM-CNET ControlNet Communications Module User Manual
Page 103

Troubleshooting the ControlNet Module and Network
8-9
9
Online @ 500kbps
The module and DPI product are
communicating at 500 kbps.
10
Bad Host Flt
The module was connected to an incompatible
product.
11
Dup. Port Flt
Another peripheral with the same port number
is already in use.
12
Type 0 Login
The module has logged in for type 0 control.
13
Type 0 Time Flt
The module has not received a type 0 status
message within the specified time.
14
DL Login
The module has logged into a datalink.
15
DL Reject Flt
The host rejected an attempt to log in to a
datalink because the datalink is not supported
or is used by another peripheral.
16
DL Time Flt
The module has not received a datalink
message within the specified time.
17
Reserved
Not used.
18
Control Disabled
The module has sent a “Soft Control Disable”
command to the DPI product.
19
Control Enabled
The module has sent a “Soft Control Enable”
command to the DPI product.
20
Message Timeout
A Client-Server message sent by the
peripheral was not completed.
21
Flt Cfg Error
Flt Cfg for the Reference or Data links is set to
a value greater than 65535 and the drive is set
for 16-bit.
22
App CRC Flt
Start-up sequence detected corrupt
application firmware.
23
App Updated
Start-up sequence detected new application
firmware in candidate area.
24
CN Comm Flt
The module detected a fault condition on the
ControlNet network.
25
CN Sent Reset
The peripheral received a reset from the
network.
26
CN Close Fit
An I/O connection from the network to the
peripheral was closed.
27
CN Idle Flt
The peripheral is receiving “idle” packets from
the network.
28
CN Open
An I/O connection to the peripheral from the
network has been opened.
29
Net Timeout Flt
An I/O connection from the network to the
peripheral has timed out.
30
PCCC IO Close
The device sending PCCC Control messages
to the peripheral has sent the PCCC Control
Timeout to a value of zero.
Table 8.6 – Event Codes and Descriptions
Code
Event
Description