Rockwell Automation Ethernet Design Considerations Reference Manual - Manual (Page 68)

68 Rockwell Automation Publication ENET-RM002C-EN-P - May 2013
Chapter 4 EtherNet/IP Protocol
Table 14 - Additional ControlLogix EtherNet/IP Communication Module Specifications
Cat. No. Series Firmware
Revision
RSLogix 5000
Software Version RSLinx Software
Version Packet Rate Capacity (packets/ second) (2) Support for
Extended
Environment
(4)
Integrated Motion
on the EtherNet/IP
Network Axes
I/O HMI/MSG
1756-ENBT Any Any 8.02.00 or later 2.30 or later 5000 900 No N/A
1756-EN2F A 2.x 15.02.00 or later 2.51 or later 10,000 2000 No N/A
3.6 or later 18.02.00 or later
(1)
25,000
(3)
Up to 4 axes
supported
(5)
B Up to 8 axes
supported
(5)
1756-EN2T A 2.x or earlier 15.02.00 or later 2.51 or later 10,000 2000 No N/A
3.6 or later 18.02.00 or later
(1)
25,000
(3)
Up to 4 axes
supported
(5)
B 2.x 15.02.00 or later 10,000 N/A
3.6 or later 18.02.00 or later
(1)
25,000
(3)
Up to 4 axes
supported
(5)
C Up to 8 axes
supported
(5)
1756-EN2TXT B 2.x 15.02.00 or later 2.51 or later 10,000 2000 Yes N/A
3.6 or later 18.02.00 or later
(1)
25,000
(3)
Up to 4 axes
supported
(5)
C Up to 8 axes
supported
(5)
1756-ENT2TR A 2.x 17.01.02 or later 2.55 or later 10,000 2000 No N/A
3.6 or later 18.02.00 or later
(1)
2.56 or later 25,000
(3)
Up to 4 axes
supported
(5)
B Up to 8 axes
supported
(5)
1756-EN2TRXT A 5.028 or later 20.01.00 or later 2.56 or later 25,000
(3)
2000 Yes N/A
1756-EN2TSC A 5.028 or later 20.01.00 or later 2.56 or later 25,000 (3) 930 with encryption
1800 without encryption No N/A
1756-EN3TR A 3.6 or later 18.02.00 or later
(1)
2.56 or later 25,000
(3)
2000 No Up to 255 axes
supported
(5)
9300-ENA A 1.12 or later N/A N/A N/A — No N/A
(1) This version is required to use CIP Sync technology, Integrated Motion on the EtherNet/IP Network, or Exact Match keying.
(2) For more information on Packet Rate Capacity, see
Packets Rate Capacity on page 69 .
(3) The packet rate capacity can change slightly depending on the firmware revision of your EtherNet/IP communication module. For more information, see Packets Rate Capacity on page 69 .
(4) Module operates in a broad temperature spectrum, -20…70 ºC (-4…158 ºF), and meets ANSI/ISA-S71.04-1985 Class G1, G2 and G3, as well as cULus, Class 1 Div 2, C-Tick, CE, ATEX Zone 2 and SIL 2
requirements for increased protection against salts, corrosives, moisture/condensation, humidity, and fungal growth.
(5) This value assumes the use of a 1756-L7x ControlLogix controller. For a 1756-L6x ControlLogix controller, see ControlLogix Controllers User Manual, publication 1756-UM001 .