Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 180)

Index-2 MD65 AC Drive User Manual
model numbers , 2-2
mounting , 3-1 to 3-6
operating conditions , 3-2
powering up after installing , 7-2
ratings , 2-2
storage guidelines , 2-4
troubleshooting , 10-1 to 10-11
Drive Overload fault , 10-5
Drive Status (d006) , 9-47
Drive Temp (d024) , 9-52
Drive Type (d017) , 9-50
Dynamic Brake Modules , E-2
E
Elapsed Run Time (d018) , 9-50
EMC Line Filters , E-4
F
fault
buffers, see, Fault n Code
(d007-d009)
clearing automatically , 10-2
clearing manually , 10-2
codes, about , 10-1
descriptions and corrective
actions , 10-3
log, see, Fault n Code (d007-d009)
Fault 1 Code (d007) , 9-47
Fault 2 Code (d008) , 9-47
Fault 3 Code (d009) , 9-47
Fault Clear (A100) , 9-29
faults
Analog Input Loss , 10-4
Auto Restart Tries , 10-4
Auxiliary Input , 10-3
Comm Loss , 10-5
Drive Overload , 10-5
Ground Fault , 10-4
Heatsink OverTemp , 10-4
HW OverCurrent , 10-4
I/O Board Fail , 10-6
Motor Overload , 10-3
Motor Stalled , 10-3
OverVoltage , 10-3
Parameter Checksum , 10-6
Params Defaulted , 10-5
Phase Short , 10-5
Phase to Ground Short , 10-4
Phase UW Short , 10-5
Phase V to Gnd , 10-4
Phase VW Short , 10-5
Phase W to Gnd , 10-4
Power Loss , 10-3
Power Unit , 10-5
SVC Autotune , 10-5
SW OverCurrent , 10-5
UnderVoltage , 10-3
filter, RFI , 4-2
Flux Current Ref (A129) , 9-38
Flying Start En (A096) , 9-28
frames and ratings , 2-2
fuses , 5-6 to 5-8 , A-2
G
Ground Fault , 10-4
ground fault monitoring , 4-1
grounding the drive , 4-1 to 4-2
H
Heatsink OverTemp fault , 10-4
HW OverCurrent fault , 10-4
I
I/O Board Fail fault , 10-6
I/O wiring , 6-4
I/O wiring examples , 6-6 , 6-9
input potentiometer , 6-6
input power conditioning , 5-4
installation , 7-1
Internal Freq (A069) , 9-19
IR Voltage Drop (A128) , 9-38
J
Jog Accel/Decel (A079) , 9-21
Jog Frequency (A078) , 9-20
jumper, removing , 5-3
K
key descriptions , 8-3
keypad components , 8-1
kits , 2-3
L
Language (A108) , 9-31
LED descriptions , 8-2