Rockwell Automation RECOMM-PBUS PROFIBUS Communications Module - Manual (Page 30)

4-6 PROFIBUS Communications Module
4.5.2 Resetting the Module
Changes to switch settings or some module parameters require that
you reset the module before the new settings take effect. You can
reset the module by cycling power to the drive or by using module
parameter 8 (Reset Module).
Set parameter 8 (Reset Module) to “Reset Module.” See figure 4.5.
When you enter 1 (“Reset Module”), the module will be
immediately reset. When you enter 2 (“Set Defaults”), the module
will set all module parameters to their factory-default settings. The
value of this parameter will be restored to 0 (“Ready”) after the
module is reset.
!
ATTENTION: If the module is transmitting control
I/O to the drive, the drive may fault when you reset
the module. Determine how your drive will respond
before resetting a connected module. Failure to
observe this precaution could result in bodily injury
or damage to equipment.
Figure 4.5 – Reset Screen on an LCD OIM
Port 5 Device
RECOMM-PBUS
Parameter #: 8
Reset Module
1
Reset Module
Value Description
0 Ready (Default)
1 Reset Module
2 Set Defaults