Rockwell Automation RECOMM-PBUS PROFIBUS Communications Module - Manual (Page 14)

2-2 PROFIBUS Communications Module
2.2 Required Equipment
Table 2.1 lists the equipment shipped with the PROFIBUS module.
When you unpack the module, verify that the package includes all
of these items.
Table 2.2 lists user-supplied equipment also required to install and
configure the PROFIBUS module.
Table 2.1 – Equipment Shipped with the PROFIBUS Module
Item Description
One RECOMM-PBUS PROFIBUS module
A 2.54 cm (1 in) and a 15.24 cm (6 in) Internal Interface cable (only
one cable is needed to connect the module to the drive)
One grounding wrist strap
One floppy disc with GSD file
PROFIBUS Module User Manual (D2-3479)
Table 2.2 – Required User-Supplied Equipment
Item Description
Small flathead screwdriver
PROFIBUS cable
One 9-pin, male D-Sub PROFIBUS connector.
Note: PROFIBUS connectors are available from a variety of
sources and in various sizes. As such, there may be mechanical
limitations that prohibit the use of some connectors. Phoenix
Subcon Plus M1 (Part # 2761826) or ERNI PROFIBUS vertical
(Node Part # 103658 and Termination Part # 103659) are
recommended for use with SP600 drives.
Configuration tool, such as:
• LCD OIM
• VS Utilities
• with RECOMM-232 Serial Converter
PROFIBUS configuration software
Controller configuration software