Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 199)

Compliance with Machinery Safety Standard EN 60204-1: 1992 D-1
A
PPENDIX
D
Compliance with Machinery Safety
Standard EN 60204-1: 1992
The GV3000/SE drive complies with the following sections of standard
EN 60204-1: 1992.
EN60204-1
Section Title
6 Protection against electrical shock
6.2.1 - Protection by enclosure
6.2.3 - Protection against residual voltages
6.3.1 - Protection by automatic disconnect of supply
6.4 - Protection by the use of PELV (Protective Extra Low Voltage)
7 Protection of equipment
7.2 - Overcurrent protection
7.2.3 - Control circuits
7.2.6 - Transformers
7.5 - Protection against supply interruption or voltage reduction and subsequent restoration
8 Equipotential bonding
8.2.1 - General (the PE terminal)
8.2.2 - Protective conductors (connection points)
8.2.3 - Continuity of the protective bonding circuit
8.2.7 - Protective conductor connecting points
8.3 - Bonding to the protective bonding circuit for operational purposes
8.4 - Insulation failures
8.5 - Bonding to a common reference potential
8.6 - Electrical interferences
9 Control circuit and control functions
9.1.1 - Control circuit supply
9.1.3 - Protection
9.1.4 - Connection of control devices
9.2 - Control functions
9.2.1 - Start function
9.2.2 - Stop function
9.2.3 - Operating modes
9.2.5 - Operation
9.2.5.3 - Stop
9.2.5.6 - Hole-to-run controls