Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 32)

32 Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Chapter 2 Add a Kinetix 350 Drive to an RSLogix 5000 Project
• The tasks described in Chapter 1, Prepare the Kinetix 350 Drive Hardware on page 13 ,
include the following:
– Prepare the Panel
– Mount the Kinetix 350 Drive
– Ground the Kinetix 350 Drive
– Disable the Safe Torque-off Feature
– Wire the Back-up Power Connector
– Wire the Input Power Connector
– Wire the Motor Power Connector
– Apply the Motor Cable Shield Clamp
– Wire the Motor Feedback Connector
– Connect the Kinetix 350 Drive to the EtherNet/IP Network
– Assign an IP Address to the Kinetix 350 Drive
What You Need
You need RSLogix 5000 software to complete the tasks described in this chapter.