Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start - Manual (Page 10)

10 Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012
Preface
How Hardware is Connected
This graphic shows an example control system that uses a Kinetix 350 drive.
Required Software
To complete examples in this quick start, you need RSLogix 5000 software. RSLogix 5000
software is required to create or change RSLogix 5000 projects that use Kinetix 350 drives.
IMPORTANT This quick start uses RSLogix 5000 software, version 20.00.00 or later, because the example Logix5000 controller, and
associated tasks, described herein are completed in a CompactLogix 5370 L3 control system. CompactLogix 5370 L3
control systems require RSLogix 5000 software, version 20.00.00 or later.
If you connect a Kinetix 350 drive over an EtherNet/IP network in a Logix5000 control system that uses a different
Logix 5000 controller, the minimum version may differ.
2
3
5
4
1
R W P
Logix5000
Controller
Stratix 2000

Switch
Computer with
RSLogix 5000 Software
MP-Series

Rotary Motor
Single-phase Input Power
Shunt
Resistor
Motor Feedback Cable
Kinetix 350
Drive
Terminal Expansion Block
1734 POINT I/O

Modules
PanelView

Plus Terminal
AC Line Filter