Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL User Manual

Page 15

Chapter 3
Installing the Bulletin 2705 Keypad Module

3–4

To install the module, follow these guidelines:

Step 1 -

Cut an opening in the panel approximately 5.86” (149mm) H x
8.61” (219mm) W. See Figure 3.3.

Figure 3.3
Mounting Dimensions of the Module

Step 2 -

Drill six 0.312” (7.6mm) diameter holes for the top and bottom
mounting brackets. A template is provided with the module to
assist in this operation.

Step 3 -

Slide the module through the opening. The mounting tabs will help
seat the module tightly against an .062” (1.6mm) to .125” (3.2mm)
thick enclosure.