Rockwell Automation 1794-ASB/E Remote I/O Adapter Module User Manual - Manual (Page 65)

Publication 1794ĆUM009D-EN-P - April 2004
A
adapter switchsettings, 2-8
addressing, 32 point standard, 3-7, 3-15
addressing mode selection switches, 2-9
addressing modes, 3-2
B
block transfer
read, 1-2
write, 1-2
C
communication rate switch, 2-10
compact mode, 3-8
complementary addressing mode, 3-12
complementary rack switchsettings, 2-15
components, hardware, 1-3
connecting wiring, 2-7
D
data table mapping, 3-16
defining racks in Flex I/O, 3-17
determining rack size, 3-16
diagnostic indicators, 1-3
F
fault conditions, 4-1
H
hold inputs, 2-8
hold inputs switch, 2-8
hold last state switch, 2-10
I
I/O rack number, 2-8
I/O rack number switches, 2-8
indicators, 4-1
L
last chassis switch, 2-9
M
mapping, data into image tables, 3-16
mode
addressing, 3-2
compact, 3-8
complementary addressing, 3-12
standard, 3-6
mode selection switches, 2-12
mode switches, 2-9
mounting on a DIN rail
before installing terminal bases, 2-3
on an existing system, 2-4
mounting on a wall or panel, 2-5
P
power requirements, 2-3
primary rack switchsettings, with
complementary, 2-15
processor lockout switch, 2-10
R
rack definition, 3-17
rack image, 3-16
remote I/O cable, connecting the wiring,
2-7
removing the adapter, 2-4
replacing an adapter, 2-4
S
safe state values, 3-18
selecting the mode, 2-12
setting the address switches, 2-13, 2-15
specifications, A-1
standard mode, 3-6
starting I/O group, 2-8
switchsettings, 2-8
Index