TerraWave BTRM-200 User Manual
Page 8
VENTEV INNOVATIONS BTRM200 Battery Test Remote Monitoring System – User Guide V1.0
8
5.4. Setting IP address information for BTRM default
Using a direct connection to the device with a
cross connected cable or using a network switch
(hub), use the manual IP settings shown on the
right. This property dialog can be found in the
TCP/IP properties, which is a sub dialog of the
Network Connections Properties, both found in
Control Panel Network Connections.
(Typically the default gateway and DNS server
need not be entered.)
If using a router, check your local area connection settings to see if the router gateway
address is the same as the default device gateway
of 192.168.1.1. If it’s not, you will need to use a
direct connection as described above to change
the device gateway address to match the router’s
gateway address.
5.5. Verify IP address information
For the initial configuration of the BTRM and to change Network IP settings for
placement in an IP based network you will need to connect the BTRM directly to your
PC. Once connected to your PC you will be able to configure the BTRM to match your
network settings.