Skyjacker FAA303 - Manual (Page 5)

26. Attach the new Skyjacker upper A-arms to the OEM steering knuckles
using the OEM hardware & a 13mm socket. (See Photo # 16)
27. Install the new Skyjacker lower A-arms using the OEM hardware & a
15mm socket. (See Photo # 17)
28. Attach the new Skyjacker lower A-arms to the OEM steering knuckles
using the OEM hardware & a 13mm socket. (See Photo # 18)
29. Attach the OEM brake caliper assemblies to the OEM steering
knuckles using the OEM hardware & a 15mm socket. (See Photo
# 19)
30. Drill the front upper bumper assembly mounting locations using a
3/8" drill bit & drill the rear upper bumper assembly mounting
locations using a 7/16" drill bit. (See Photo # 20)
31. Install the new Skyjacker upper bumper brackets to the OEM front
bumper assembly using the supplied crush sleeves, 3/8" x 2 1/2"
bolts, 7/16" x 2 1/2" bolts, washers, nuts, 9/16” socket, & a 5/8"
socket. (See Photo # 21) Note: Do not tighten at this time.
32. Attach the OEM front bumper assembly to the OEM upper mounts
using the OEM hardware & a 15mm socket. (See Photo # 22)
Note: Do not tighten at this time.
I-FAA303 Pg 5
Photo # 16
Photo # 17
Photo # 18
Photo # 19
Photo # 20
Photo # 22
Photo # 21