Roxul Industrial Insulation Process - Manual (Page 95)

2.1 Norms & Standards
2.1.2 Insulation specification
g) European standardization (CEN)
In order to remove technical barriers to trade, the
European Union decided to develop uniform
European product standards. These product
standards describe the product properties, as well
as the methods of testing for these properties. The
minimum requirements for certain product
properties still remain a national responsibility and
are laid down in each individual country. The EU
issues orders in the form of mandates to CEN (the
European Committee for Standardization), which
they use uses to develop relevant standards.
For ProRox ® insulation, this product standard is the
EN 14303 “Thermal insulation products for building
equipment and industrial installations – Factory-
made mineral wool (MW) products – specification”.
Following ratification, a European standard must
be adopted as it stands by the national standardiza-
tion organizations as a national standard. Deviating
national standards must be retracted. Each
European standard adopted is published in each EU
country with a national prefix, e.g. in Germany:
DIN-EN-XXXX; in England (British Standard):
BS-EN-XXX
Insulation
materials
(Material
standards)
CINI 2.2.01 Stone wool boards (slabs): ProRox ® boards (slabs) for the thermal insulation of equipment
CINI 2.2.02 Wired mats: ProRox ® wire mesh blankets for the thermal insulation of large diameter pipes, flat walls and equipment
CINI 2.2.03 Pipe sections: ProRox ® pipe sections and prefabricated elbows for the thermal insulation of pipes
CINI 2.2.04
Loose wool: Loose stone wool (mineral wool) without binder for the thermal insulation of valve boxes and the specification stuffing
of insulation mattresses
CINI 2.2.05 Lamella mats: ProRox ® lamella mats for the thermal insulation of air ducts, pipe bundles and equipment
CINI 2.2.06
Aluminum faced pipe sections: ProRox ® pipe sections with reinforced pure aluminum foil facing for the thermal
insulation of pipes
Cladding
(Material
standards)
CINI 3.1.02 Aluminized steel sheeting: Aluminized steel cladding for the finishing of insulation
CINI 3.1.03 Alu-zinc coated steel sheet: Alu-zinc steel cladding for the finishing of insulation
CINI 3.1.04 Galvanized steel sheet: Continuous hot dip (Sendzimir) galvanized steel cladding for the finishing of insulation
CINI 3.1.05 Austenitic stainless steel: Stainless steel cladding for the finishing of insulation
CINI 3.1.11 GRP: Weather resistant UV-curing glass fiber-reinforced polyester (GRP)
Processing
guidelines
CINI 1.3.10
General processing guidelines: Installation instructions for the thermal insulation of hot pipelines and equipment (insulated with
mineral wool)
CINI 4.1.00a Pipes: (Overview) piping insulation details
CINI 4.2.00 Columns: (Overview) insulation/finishing details overview columns
CINI 4.3.00 Vessels: (Overview) insulation/finishing detail overview vertical vessels
CINI 4.4.00 Heat exchangers: (Overview) insulation/finishing details overview horizontal heat exchangers
CINI 4.5.00 Vessels: (Overview) insulation/finishing details for tanks (operating temperature from 68 °F (20 °C) to 356 °F (180 °C)
CINI 7.2.01 Corrosion protection: Corrosion protection under insulation
92