Robustel M1000 User Guide - Manual (Page 47)

Robustel GoRugged M1000 User Guide
RT_UG_M1000 _v.2.0.0
20.12.2013 46 / 83
Confidential
Debug
Item Description Default
“Receive” windows
Display the command replied by the cellular module after sending the
AT commands
N/A
“Send” windows Input the AT commands in this windows AT
Enter
The same as “Enter” in windows Hypter Terminal, click to enable or
disable Enable
Ctrl+z
The same as “Ctrl+z” in windows Hypter Terminal, click to enable or
disable Disable
Echo
Enable or Disable the Echo.
Note: 2-wire RS-485 uses half-duplex communication. For this reason,
the modem’s local echo should be disabled. Enable
“Send” button Click to send out the AT commands and in “Send” windows N/A
Clear Click to clear the “Receive” windows
1. Select 19200 bps, then click “Change Baudrate to”, after that Current Baud Rate will also auto change to 19200
bps (it will auto display “AT+IPR=19200” and “OK” in Receive windows);