MacDon R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers - Manual (Page 132)

MAINTENANCE AND SERVICING
Figure 7.20: Cutterbar Filler Plug Locations
9. Locate one of the three filler plugs along the top of the
cutterbar. Refer to Figure 7.20: Cutterbar Filler Plug
Locations, page 124 .
10. Clean around either filler plug (A) and remove one plug
with an 8 mm hex Allen L-key.
NOTE: Rotate disc to expose filler plug if
necessary.
11. Add lubricant to cutterbar through filler hole (A). See
Section 7.4 Recommended Fluids and Lubricants,
page 110 .
IMPORTANT
DO NOT overfill the cutterbar. Overfilling can
cause overheating and damage to or failure of the
cutterbar will occur.
12. Install the filler plug that was removed.
13. Close cutterbar door(s). See Section 5.5 Cutterbar
Doors, page 31 .
14. Start engine and raise header off blocks.
15. Engage header safety props.
16. Remove blocks and lower header.
17. Stop engine and remove key from ignition.
18. Disengage header safety props.
19. Start engine and lower header to the ground.
169457
124
Rev. F