MacDon R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers - Manual (Page 101)

OPERATING THE HEADER
6.13 Stripper Bars
There are two adjustable stripper bars installed on the
pan at both ends of the auger that minimize wrapping of
material around the auger. The factory position should be
satisfactory for most crops but bars can be adjusted for
specific conditions.
For fine stemmed crop, the auger performs best when the
stripper bars are positioned as close as possible to the
auger without rubbing.
Component wear and cutting in bumpy terrain where the
auger can contact the stripper bar may cause clearances
to become excessive resulting in feeding problems and
uneven windrows.
If material starts to accumulate between the auger flighting
and the strippers, the gap will need to be adjusted.
NOTE: The stripper bars will likely require
adjustment if the auger position
is changed.
Figure 6.40: RH Side Shown, LH Opposite
6.13.1 Adjusting the Stripper Bar
If necessary, adjust the stripper bar as follows:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower header to ground, shut down windrower, and
remove key.
2. Open cutterbar doors. Refer to Section 5.5 Cutterbar
Doors, page 31 .
3. Open driveshield. Refer to Section 5.4 Driveshields,
page 28 .
4. Loosen nuts (A) on the two bolts securing stripper
bar to the pan sufficiently so that stripper bar can
be moved.
Figure 6.41: Left End
169457
93
Rev. F