MacDon R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers - Manual (Page 122)

MAINTENANCE AND SERVICING
7.5.2 Break-In Inspections
Timing Item Refer to
Check for loose hardware. Tighten
to required torque.
Section 7.2 Torque Specifications, page 100 .
At 5 hours
Check drive belt tension.
At 25 hours Check drive belt tension.
Check drive belt tension.
Inspecting the Conditioner Drive Belt, page 142 and
Inspecting the Auger Drive Belts, page 150 .
Change cutterbar lubricant.
Section 7.5.8 Lubricating the Cutterbar, page 121 . Use
Only Specified Amount. Do NOT overfill.
Change conditioner gearbox
lubricant
Changing the Conditioner Gearbox Lubricant, page 146
At 50 hours
Change bevel gearbox lubricant. Changing the Bevel Gearbox Lubricant, page 141
Change cutterbar lubricant. Section 7.5.8 Lubricating the Cutterbar, page 121 .
Change conditioner gearbox
lubricant.
Changing the Conditioner Gearbox Lubricant, page 146
At 150 hours
Change bevel gearbox lubricant. Changing the Bevel Gearbox Lubricant, page 141
7.5.3 Preseason/Annual Service
CAUTION
• Review the operator’s manual to refresh your memory on safety and operating recommendations.
• Review all safety signs and other decals on the header and note hazard areas.
• Be sure all shields and guards are properly installed and secured. Never alter or remove
safety equipment.
• Be sure you understand and have practiced safe use of all controls. Know the capacity and the
operating characteristics of the machine.
• Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following at the beginning of each operating season:
• Lubricate machine completely. Refer to Section 7.5.5 Lubrication and Servicing, page 115 .
• Perform all annual maintenance. Refer to Section 7.5.1 Maintenance Schedule/Record, page 112 .
169457
114
Rev. F